Banner

Boring and welding integrated machine electric control box

Boring and welding integrated machine electric control box
Boring and welding integrated machine electric control box

The electric control box of the boring and welding machine is mainly composed of one or more low-voltage switchgear and various control, adjustment and measurement components, which is actually a kind of component on the boring and welding machine.

In the process of wiring, the following items should be paid attention to:

1. All wiring connections outside the panel must be connected to those inside the box, and there should be no joints in the middle of the line, otherwise unnecessary danger will occur.

2. The wiring outside the panel should be protected by appropriate methods, such as: steel pipes, hoses, etc., and the wiring should be connected to a place that is not easily damaged.

3. The connection wires or power wires between the machine tools outside the panel must be put into the bridge frame. The bridge frame should be supported by the base and cannot be connected to the ground.

4. All connection boxes and wire entrances outside the panel need to be protected, and the protection level must reach IP55 or above.

5. For the connection of some heating equipment such as packaging machines, the wiring cannot be installed near the heating place. The wiring is carried out in a connection box with a terminal block. The heater connection needs to use ceramic tube wires or glass wires, and flammable wires cannot be used. sex wires.