Banner

新闻详情

Home > News Center > Content

Instructions for using mobile boring machine

Edit:Xinxiang Blueprint Machinery Co., Ltd.UpDate:2021-05-19

Boring machine is a kind of machine that can carry out deep hole processing. It is specially designed for boring 2. This kind of machine is generally used in the deep hole processing technology of gasoline cylinders, hydraulic cylinders, machine tools and other equipment. In addition, mobile There are many other uses of the boring machine, such as the boring of automobiles, the machining of the inner holes of mechanical parts, the inner holes of pipes, the machining of ship shaft holes, the concentric holes of loaders, etc. Care should be taken when drilling.

1. Before the machine works, lubricating oil should be added in advance to each oil injection hole and the parts that need to be lubricated.

2. When the power is turned on, the leakage protector should be connected at the same time, and the ground wire should be connected to ensure the safety of work.

3. Use the centering cone to fix the boring bar of the mobile boring machine so that the boring bar is basically concentric with the processed hole, then fix the front and rear fixed plates of the mobile boring machine on the processed object (welding is generally required), and then gradually After installing the main engine, motor, equipment and workpiece, remove the centering cone.

4. Fasten the boring tool to the boring bar that is 5-10mm away from the hole to be bored. Firstly, rough boring. During rough boring, the boring amount can be controlled below 2mm on one side. Therefore, when fixing the tool bar, the machining Measure it down.

5. In order to meet the actual needs in processing, this machine is equipped with a manual device at the end of the screw under the motor. Shake the handle, the screw and the nut can be fed synchronously, and the user can adjust the cutting speed by himself. speed.

With the rapid development of industrial technology, the quality requirements for mobile boring machine products are getting higher and higher. The original manual boring method can no longer meet the needs of the actual situation. The method came into being. Using the boring machine to process various mechanical shaft pin hole systems, the quality of the boring part of the blind hole step hole is far better than the quality of the manual reaming, and the boring machine can also improve the processing efficiency and shorten the production cycle.